Answers
Garage door spring replacement cost in Dallas-Fort Worth
Last reviewed September 2, 2026 · Written by the Professional Garage Concepts service team
Short answer
How much does garage door spring replacement cost in DFW?
Garage door spring replacement in Dallas-Fort Worth runs $200 to $550 for a typical residential job. Torsion springs are roughly $200 to $400 per spring installed and extension springs $150 to $350 per pair. Door size, door weight and spring wire size decide where in that band your job lands.
Why the range is that wide
Three things move the number. The first is spring type. A torsion spring mounts on a shaft above the door and carries more load per spring, so it costs more than an extension spring hanging beside the track. The second is door weight, which drives wire size and inside diameter. A heavy insulated three-layer double door needs a fatter wire than a builder-grade single-layer pan door, and that part costs more. The third is cycle rating. A 10,000-cycle spring is the builder standard and the cheapest. A 20,000 or 30,000-cycle spring costs more up front and lasts two to three times as long, which is usually the better buy in a household with two drivers.
Why a quote for one spring is a red flag
On a two-spring door, both springs were installed on the same day and have carried identical load ever since. When one fails the other is at the same point in its service life, usually within weeks or months of its own failure. Replacing only the broken one saves maybe $150 today and buys a second service call at full price, plus another day with the car stuck inside. Every reputable shop in this market replaces in pairs. A quote that prices one spring is either a bait number or a shop that intends to see you again.
What should be included and often is not
A complete spring job is not just the spring. It includes weighing or balancing the door so the new spring is actually matched to the load, checking and usually replacing the cables, inspecting the drums and the bearings, lubricating the shaft and hinges, and re-setting the opener force and limits afterward. An opener that was fighting a failing spring for months has drifted, and if nobody resets it the door either slams or reverses on close. Ask what the quote includes before you compare two numbers.
- Both springs replaced as a pair, sized to the measured door weight
- Lift cables inspected, and replaced if frayed or kinked
- Center bearing and end bearing plates checked
- Door balance tested by hand at the halfway point
- Opener force, travel limits and safety reverse re-tested before we leave
How long a new spring should last
One cycle is one open and one close. A household that leaves and returns twice a day runs about 1,460 cycles a year, but a family with two drivers, a teenager and a dog walk habit is closer to 3,000. Against a 10,000-cycle builder spring that is a seven-year life at best and closer to three or four in a busy house. Against a 20,000-cycle spring it is twelve to fifteen years. The upgrade usually costs less than the second service call it prevents.
What to do right now if yours just broke
Stop using the opener. A garage door opener is sized to move a spring-balanced door, not to lift a 150 to 250 pound slab of steel by itself. Forcing it bends track, strips the gear, snaps the trolley, or burns the motor, and turns a spring job into a spring job plus an opener. Do not try to lift the door by hand either. If a vehicle is trapped inside and you cannot wait, call and say so. We run same-day and 24/7 emergency dispatch across DFW.
| Job | Typical installed price | Notes |
|---|---|---|
| Torsion spring, per spring | $200 to $400 | Replaced in pairs on a two-spring door |
| Extension springs, per pair | $150 to $350 | Includes safety cables where missing |
| Typical complete job | $200 to $550 | Parts, labor, balance and opener re-tune |
| High-cycle upgrade | Quoted on site | 20,000 or 30,000-cycle springs for heavy use |
| After-hours emergency | Quoted before dispatch | You approve the number before we roll |
Answers
How much does garage door spring replacement cost in DFW: follow-up questions
Still stuck? Call (817) 381-6173 and talk to someone who does this every day.
Can I replace a garage door spring myself?
You should not. A wound torsion spring stores enough energy to break an arm or worse, and winding bars are not the screwdrivers most people reach for. The parts cost is a small share of the job and the failure mode is an emergency room visit. This is the one garage repair where the professional answer is not upselling.
How long does the repair take?
About an hour for a standard two-spring torsion job, including balancing the door and re-tuning the opener. Extension springs are usually faster. If cables, drums or bearings also need replacing, add another thirty minutes.
Do you charge extra for weekends or evenings?
Emergency and after-hours calls are quoted before we dispatch, so you know the number before anyone leaves the shop. There is no travel surcharge for any DFW city we serve.
Will my homeowners insurance cover a broken spring?
Usually not. Springs are a wear item and standard policies treat wear as maintenance rather than a covered loss. If the spring failed because of storm or impact damage to the door, that is a different claim and worth calling your carrier about.
Get the number for your actual job
Call (817) 381-6173 or send the form. We put the price in writing before the work starts, and there is no travel surcharge anywhere in DFW.